Meeting location for the 2024/2025 Season will be at J.A. Dulude arena.  Meetings start at 7 pm.

How Much CO2 ?

Started by FISHEYE, February 27, 2007, 01:50:28 PM

Previous topic - Next topic

FISHEYE

I have just purchased a CO2 system for my 90 gallon setup.  We tried the CarboPlus system before it broke down, therefore have been using homemade CO2 for about a week now (so the plants are used to CO2).

I'm setting up my new CO2 system, but id like to know how many bubbles per second I should use for the 90 gallon tank with 3 watts per gallon lighting.

Zoe


BigDaddy

Start at 1 bubble per second and monitor over the course of the day... increase on a daily basis until you routinely measure 25ppm of CO2 at any point during lights on

FISHEYE

Okay so I just got a CO2 canister with all the trimmings and I can't figure out how to work it.
The silver valve on top is on Open.
One of the guages has a reading... the other doesn't.
The black handle is twised to be open.
The specific valve on the 6 way co2 splitter Manifold is open.
The bubble counter has water in it, with a tube leading into the tank where there's a diffuser and a water pump.
What am I missing?  No CO2 is coming out. :o

BigDaddy

have you tried one of the other needle valves, just in case?

FISHEYE

Tried how? What do I need to do?

charlie

fisheye i sent you a pm.
Regards

busdriver

Quote from: BigDaddy on February 27, 2007, 03:06:36 PM
Start at 1 bubble per second and monitor over the course of the day... increase on a daily basis until you routinely measure 25ppm of CO2 at any point during lights on
BD, you should write a book on all this info.
I know I would buy it.
Like PFG says "I miss this place and all the people associated with it."